| Error code |
Symptom or error |
FRU or action, in sequence |
|---|---|---|
| 0175 | Bad CRC1, stop POST task. The EEPROM checksum is not correct. | System board |
| 0187 | EAIA data access error | System board |
| 0188 | Invalid RFID serialization information area or bad CRC2. กก |
System board |
| 0189 | Invalid RFID configuration information area. กก |
System board |
| 0190 | Critical low battery error. | 1. Charge the battery pack. 2. Battery pack. |
| 0200 | Fixed disk failure | 1. Reseat the hard disk drive. 2. Load Setup Defaults in IBM BIOS Setup Utility. 3. Hard disk drive. 4. System board. |
| 021x | Stuck key. Keyboard or auxiliary input device error |
Run interactive tests of the keyboard and the auxiliary input device. |
| 0220 | Monitor type does not match CMOS กก |
Load Setup Defaults in IBM BIOS Setup Utility. |
| 0230 | Shadow RAM failure at offset nnnn | System board |
| 0231 | System RAM failure at offset nnnn | 1. DIMM 2. System board. |
| 0232 | Extended RAM failure at offset nnnn | 1. DIMM 2. System board. |
| 0250 | System battery is dead - replace and run setup | Replace the backup battery and run IBM BIOS Setup Utility to reset the time and date. |
| 0251 | System CMOS checksum bad - Default configuration used | Replace the backup battery and run IBM BIOS Setup Utility to reset the time and date. |
| 0252 | Password checksum bad. | Reset the password by running IBM BIOS Setup Utility. |
| 0260 | System timer error | 1. Replace the backup battery and run IBM BIOS Setup
Utility to reset the time and date. 2. System board. |
| 0270 | Real time clock error | 1. Replace the backup battery and run IBM BIOS Setup
Utility to reset the time and date. 2. System board. |
| 0271 | Date and time error | Run IBM BIOS Setup Utility to reset the time and date. |
| 0280 | Boot incomplete error - Default configuration used | 1. Load Setup Defaults in IBM BIOS Setup Utility. 2. DIMM. 3. System board. |
| 02B2 | Incorrect drive A type. | Diskette drive. |
| 02D0 | System cache error | |
| 02F4 | EISA CMOS not writable. | 1. Load Setup Defaults in IBM BIOS Setup Utility. 2. Replace the backup battery. 3. System board. |
| 02F5 | DIMM test failure | 1. DIMM. 2. System board. |
| 02F6 | Software NMI failure | 1. DIMM. 2. System board. |
| 02F7 | Fail-safe timer NMI failure | 1. DIMM. 2. System board. |
| 1801 | Attached docking station is not supported. | Shut down the computer and remove it from the docking station. |